B7020 .07 1/16 RC Glow Nitro Engine Rotary Carburettor Side Exhaust

B7020 .07 1/16 RC Glow Nitro Engine Rotary Carburettor Side ExhaustComplete with pull starter Preinstalled rotary carburettor Side exhaust engine (round exhaust 16mm outer diameter with gasket on or 12. 5 13mm without gasket on, gasket included) 1. 2v glow plug included (can be removed with a 7mm hex wrench) Two sets of mounting points Engine base 13mm between side by screw holes and 22mm to the furthest away screw hole (total of 3 screw mounting points). Second mount point is at the side of the engine they are 10mm

T-Connector T-Plug Male and Female 1 Pair

Suitable for some 1/16 scale models - not all the same check measurements below to ensure a fit

360 degree top plate swivel with friction padding to prevent slip

17mm center hex (to fit 17mm hub - hex)

http://www

This is the standard normal size to fit motors 36mm in diameter

Requires a 6v input

The file is large so will need time to load up (each one about 1

12mm Hex Fitting 32mm Length (end to end) 32mm High (end to end) 27mm across center fixing holes 19mm Deptch Other starters in stock simple ask and give the height length and the hex (nut size) of your current pull starter

18mm between center of servo cog to furthest screw center (measured on 1 arm)

214mm long end to end

50mm Width