TD10031 1/8 RC Alloy 3 Shoe 14T Clutch Kit Silver Flywheel + Shoes + Bearings

TD10031 1/8 RC Alloy 3 Shoe 14T Clutch Kit Silver Flywheel + Shoes + Bearings3 Shoe Clutch Kit To suit 1 8 scale models made by Hi Speed, will fit a few other models using a . 21+ engine (not all). To help ensure a fit please check measurements below: 14T Clutch Housing 20. 4mm wide outer diameter 28. 1mm 2 x Ball Bearings included 10mm x 5mm x 4mm (ODxIDxW) Lightweight alloy flywheel: Outer diameter 34. 40mm Center hole dia 8. 6mm Axle to fit 6mm crankshaft thread 11. 1mm long (entire length) What to check to ensure a fit?

High quality single chamber alloy rear end exhaust pipe to fit the HPI Savage

Measures 270mm between wheel arches

Upgraded air filter to increase performance by allowing your engine to breath easier

This is a prepainted body shell but requries cutting + drilling

This is a prepainted and cut body shell but requires cutting

Body shell is fully painted as shown

If your rc car is over 2 years old you will need the larger pull starter which features a 32mm (top right to top left center screw hole) backplate with a 14mm hex

15mm Depth to the hex mount

Note: one way bearing not included

40mm top right to top left fixing hole centers

Suitable for some 1/16 scale models - This is a prepainted body shell but requries cutting + drilling

12mm Drive Hex Mounts