Magnetic Suction Cup Antenna With 30 Meters Cable & SMA Connector (Model 0020917)

Magnetic Suction Cup Antenna With 30 Meters Cable & SMA Connector (Model 0020917)Features: Model No.: 0020917 Work with wireless RF system Frequency Range: 300~450MHz Impedance: 50 Antenna Length: 15cm Cable Length: 3000cm Weight: 380g Anti interference, waterproof, shielded wire set inside Magnetic stand design for easy to install With SMA connector Application: Used for receivers and transmitters The device has farther working range with magnetic suction cup antenna than with telescopic antenna.

Stroke and Length (Model 0041550) Parameter Value Stroke 900mm Retraction Length 1200mm (center distance between two mounting holes when the linear actuator is fully retracted) Extension Length 2100mm (center distance between two mounting holes when the linear actuator is fully extended) The linear actuator has two built-in limit switches

if connect two terminals of S2

You can operate the linear actuator to extend or retract by the transmitter

1 x Receiver: S4XW-DC-ANT3

The operation of Interlocking mode with the transmitter CC-2:

at this time release the learning button

and connect terminal <-> to the negative pole of DC lamp

and the receiver enters the channel number switching status

resulting in a retraction length of 505 mm

and you can connect external devices (with normally closed contact)

Reliable control: The receiver only works with the transmitter which use same code

and connect the negative pole of the DC power supply to the terminals <NC> of two relays