DJI Matrice 400 Dual Gimbal Connector

DJI Matrice 400 Dual Gimbal ConnectorThe DJI Matrice 400 Dual Gimbal Connector is a payload bridge that lets the Matrice 400 fly two stabilized gimbals at the same time. It mounts between the aircraft and a pair of standard DJI Zenmuse payloads, draws power and data from the M400's E Port V2 (positions E1 and E2), and supports each payload independently through DJI Pilot 2. The result is one flight, multi sensor data collection: pair a Zenmuse P1 with an L2 for fused photogrammetry and

maximum hover time from 42 minutes to 39 minutes

Adding a payload via the upward connector will affect flight time depending on the weight of the attached payload

The GL10 is sized for the smaller Mavic 3 Enterprise platform — just 150 g and 28 W — and is spotlight + flasher only

Text-to-speech reads a typed message aloud through the speaker

328 lb (+/- 5 g) Deployment time Under 0

or who need Manual mode for acro / freestyle flight

and OGI sensors via Smart Dovetail mount

Follow the procedure in the CZI user manual and the DJI Mavic 3 Enterprise user manual to mount the payload and verify the connection before powering on the aircraft

per DJI's published lab data with no payload

The GL10 includes integrated red and blue flashing lights for emergency-vehicle visibility

while strobe modes add visibility and signaling capability for public safety missions or low‑light waypoint tracking

It's fine for short transfers between site stations