Bend Indicator Gauge, locking bar baseframe

Bend Indicator Gauge, locking bar baseframeLocking Bar Bend Indicator Gauge to Inspect Locking Bar Straightness Place hooks around locking bar on base frame. press upwards so that the ends of the angle are flush with the guide rail beneath the locking bar. Check that the device sits flat on the guide rail. Will not give accurate results if guide rail surface is deformed at the locking bar. Inspect the gap between the device and the locking bar on top and bottom. Any contact between the device

Trailer Rear Tail Light Assembly-Left

5in mounts (for front and rear crossbars) and (2) x 5in mounts (for center)

PLEASE READ **

** ONLY works on new style legs that utilize key hole design in leg cut out

in under a minute

• Four heavy duty swivel casters on the ends of the base provide stability while two wheels located in the center of the base provide easy mobility and a zero degree turning radius

Add (1) Set For Each Shelf-Rack Unit In Cart (Required for Promaster Only) **

• Rubber is mounted on top and the sides where the carts clamp together

powder coat finish

Mercedes-Benz Sprinter and Nissan NV200)

3/4" Round P2PC Red Comb

Hole size required: 0