Shell mill holder BT 50 - 27 - 40

Shell mill holder BT 50 - 27 - 40Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. SK 30 without coolant exit bores on the end faceDelivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel

Designed with fine adjustment to allow precise movement of the slider

Carbide surfaces

Ergonomic Handle of Design

For mounting and drifting taper shanks DIN 228-1 A in toolholders DIN 228-1 B

High holding forces: increase by a factor of 3 to 5 compared to standard jaws

Opening and closing of the flanks through the spindle speed control

in wooden box 701

For parting-off holders with coolant supply directly to the cutting edge

Plug gauge sizes according to DIN 2245

T-nuts 18 mmTest certificate

for fast mounting of work pieces

Further information on the articles included can be found under the respective article number