Hydraulic expansion chuck HSK 100 - 16 - 150

Hydraulic expansion chuck HSK 100 - 16 - 150Application: For mounting straight shank tools acc. DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia. 20 mm only with reduction sleeve). Note: l1 = max. clamping depth l2 = max. length adjustment range Delivery: Without wrench All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile

5 with h4-tolerance and Ø 6 - Ø 32 with h6-tolerance

Made of sturdy grey cast iron with hollow profile handles and specially guided prismatic steel jaws

High holding forces: increase by a factor of 3 to 5 compared to standard jaws

All tool sizes can be combined

For the chucking of quick change adaptors for taps

Hardened and grinded all around

The collet clamping Ø range is always up to 0

vertical and lateral

with cooling channels

Application:

without the illustrated cutting tools

for clamping holders with coolant channels directly to the cutting edge