Milling arbors for screw-in cutters BT 50 - M10 - 138 - LB100

Milling arbors for screw-in cutters BT 50 - M10 - 138 - LB100Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

With fi ne adjustment carriage to feed the slider finely

Ø 125 mm with locks

The chucking diameter is configured for a tool tolerance of h6

E3= 12 pieces

Ausführung:

800 N/mm² after DIN

which can cause high frictional forces on the thread flanks

Zero-setting at any position for incremental measurement

thin thread and pitch diameter oversize

for KEMMLER precision collet chuck ER

- Calibration certificate

Only nominal size d can be clamped (applicable up to 120 bar)