1” to 3/4” High Misalignment spacers

1” to 3/4” High Misalignment spacers(DOR. 039) High Misalignment spacer reduces a 1 inch bore to a 3 4" inch bolt hole. Installed mounting width of 2 5 8 inch (66. 68mm). Sold in Pairs, enough for 1 joint. The material used is 17 4 PH stainless steel, which offers excellent corrosion resistance compared to plated mild steel. Additionally, this material provides increased toughness, helping to prevent elongation of the holes, ensuring durability and longevity.

the trusty nut and bolt will work just fine if you don't have a Rivnut tool

The maximum length for this listing is 1 meter

4x M16 Caphead bolts grade 12

this means to have the option to switch between the two styles with the same mounts

The jam nuts required are sold separately in LH and RH thread variants

1-1/4" -12 Johnny Joint RH 5/8" Bolt hole

these are the correct length so the shank is in contact with the joint and steering arm/hub

-1x M12 Thick washer

It's a straightforward approach—position

Our first batch of Arms has been laser etched upside down do to an unfortunate drawings oversite

We found it best to drill out the bonnet to accept M8 Rivnuts

(FL018 RH)