Shrink chuck 4,5° with cooling channels HSK 63 - 16 - 160

Shrink chuck 4,5° with cooling channels HSK 63 - 16 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

A possible increase of axial force during the tapping process is reduced to a minimum

break-proof and impact-resistant ABS plastic

Synchro tapping chucks compensate synchronisation errors

Toolholders suitable for induction-

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

Low-vibration boring barsWith internal coolingLonger durability of insertsFor longitudinal and plane turningSetting angle: 93°Delivery: without inserts

which can cause high frictional forces on the thread flanks

bei Ø 6 – Ø 32 mm = h235

Schafttoleranz bei Ø 3

For longitudinal and plane turning

Sealing capacity up to 80 bar

a clip and can be moved in steps of 25 mm