Quick change tapping chuck HSK 63 - M3-M14 - Gr.1

Quick change tapping chuck HSK 63 - M3-M14 - Gr.1Application: For the chucking of quick change adaptors for taps. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Clamping screw

maximum = 50 mm)

Clamping range h6 (nominal size only)

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

For safe clamping of taps in end mill holders according to DIN 1835 B

Stainless steel

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance7

shank form UF

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

For mounting the coolant tubes in HSK toolholders

With high precision coolant you get improved

From DCONWS = 25 on two clamping screws