Shrink chuck 4,5° SK 30 - 18 - 100

Shrink chuck 4,5° SK 30 - 18 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

Only nominal size d can be clamped

For safe clamping of taps in end mill holders according to DIN 1835 B

For safe clamping of taps

Clamping range 0

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

longer tool life

Toolholders suitable for induction-

Surface hardened HRC 58~60

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

Sealing capacity up to 80 bar

With retaining screw