Milling arbors for screw-in cutters HSK 63 - M12 - 176 - LB150

Milling arbors for screw-in cutters HSK 63 - M12 - 176 - LB150Application: For mounting screw in cutters with thread. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For sealing the spindle of the turret

Without wrench

For safe clamping of taps in end mill holders according to DIN 1835 B

For the storage of collet chuck

SK 30 without coolant exit bores on the end faceDelivery:

prevents overfeeding

The tapered tool holder is thus optimally

From DCONWS = 25 on two clamping screws

For sealing tools with internal cooling in collet chucks

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

With built-in tightening bolt All holders are made of forged steel

For the storage of collets