Shrink chuck 4,5° with cooling channels SK 40 - 25 - 100

Shrink chuck 4,5° with cooling channels SK 40 - 25 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance2 For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

sleeves and tool arbors

Warranty : 1 year in normal statement

Ergonomic Handle of Design

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

Measuring contact points are designed to allow measurements near to the bottom of blind holes

DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE

and other hard to reach portions

206 x 56 x 24

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

clamping depth = 58

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

Carbide tipped scriber with clamp