N10181G 1/10 M12 12mm to M17 17mm Wheel Hex Hub Adapter Alloy Green 4 Ext. 30mm

N10181G 1/10 M12 12mm to M17 17mm Wheel Hex Hub Adapter Alloy Green 4 Ext. 30mmThis will fit 1. 10 models using a 12mm hub. Note not suitable for 2WD which uses bearings instead. Please check measurements below before ordering as this will not fit all. Simply replaces the normal 12mm hubs with these adapters. Great if looking to put

92mm thick

High quality lightweight pinion gears

Save your model from crashing with this fail safe in the event of loss of radio signal or low battery the fail safe will automatically switch the throttle servo (or steering servo if you chose) back to its preset positon like brake or to lower the revs on the engine saving you ££ off crashes

1000mm long x 15mm wide x 4mm thick

M2 screw holes 150mm long and 100mm wide

however please check the above measurements first to avoid any fitting issues

Tension is Off Road Soft

If your rc car is over 2 years old you will need the larger pull starter which features a 32mm (top right to top left center screw hole) backplate with a 14mm hex

This is powered by either a direct 6v input no batteries included or by a spare port on your receiver

To suit 1/10 scale electric models made by hi speed

10 models however not all so please check measurements below to avoid any fitting issues

Suitable for most 1