48A 11.5kW BSA Power Station™ - Premium Level 2 load balancing J1772 Charging Station for all Electric Vehicles

48A 11.5kW BSA Power Station™ - Premium Level 2 load balancing J1772 Charging Station for all Electric Vehicles48A 11. 5kW BSA Power Station Premium Level 2 load balancing J1772 Charging Station for all Electric Vehicles Premium Charging in a beautiful design for indoor outdoor use, Silver faceplate as shown. In the package, you will receive: Your very own Premium BSA Power Station Based upon the 80 amp capable Tesla Gen II Wall Connector (HPWC) with the following cables already wired in A 50amp Low Temp rubber J1772 "Whip" (plugs into car) Hardwired power

13/kWh here in Vegas) The meter is wired to read system Voltage and all current flowing through the Welder Buddy to help you stay within the 40amp total budget

If you have a Tesla Charging cable you will need to purchase one of their optional 30amp adapters

This cable is for 24amp continuous or lower load so you must set your EVSE or Electric Vehicle to no higher than 24amps

-103°F to 257°F (-75°C to 125°C) temperature range

This unit is built with a 14-50 cable one 14-50 and one 6-50 outlets

The "T" shaped slots indicates backward compatibility with 15amp plugs

If the EVSE outlet is a NEMA 14-50 as found on a Dryer Buddy #4 then the local convenience outlet will be a 14-50

This Upgrade Pak is not for existing units that are already built

The Electric Range Buddy Plus is a manual 2-way switcher based

an Upgrade Pak essentially allows you to pay the difference in cost between the original Dryer Buddy and the Dryer Buddy® Plus AUTO or Dryer Buddy® PLUS AUTO

this is technically a NEMA TT-30

Allows you to plug your 6-20R plug equipped EVSE into an older dryer outlet