5" w/Ribs

5" w/RibsThis 5" 90 degree intake hose can be used any place you have two 5" OD tubes and you need to make a 90 degree bend. Has reinforcing ribs for added strength. Temp rated at 250 275F. Recommended clamps are 94100 0550. 90HL50 90L50

You install it in the end of the 5" rubber elbow or hump hose

This short 8 inch hump hose is used to connect two 8" OD intake tubes

Mill finish (as it arrives at our location from the mill) – may have minor defects and small scratches

but no dents or major defects

This reducing insert adapts a 2-1/2" ID intake hose to a 2" OD tube

This 3" ID silicone coupler is 3 inches long and has the special matte red finish indicating aramid reinforcement

Can also be used in other applications where sizes are close - for example the 2-5/16" end will stretch to 2

This 5-inch 45-degree intake hose can be used anywhere you need to join two 5" OD tubes with a 45 degree bend

Handles 500 degrees F

This reducing insert adapts a 7" ID intake hose to a 6" OD tube

This 10" ID 90-degree intake hose can be used any place you need to make a 90-degree bend

This 3-1/2" ID high temp silicone hump is useful in any application that requires a high heat resistance